This is a beautiful and advanced napkin design. It works better with stiff material.
Step 1: Place the napkin with the printing or pattern down for you.
Step 2: Fold the napkin diagonally in half.
Step 3: Turn the napkin so that the open end is gone.
Step 4: Fold up the extremely right-wing corner diagonally so that the point rests on the top of the far corner. The edge of this new valve must be straight on the heart line.
Step 5: Repeat step four on the other side, so that the left corner is on the top of the far corner, now you create a diamond shape.
Step 6: Turn the napkin and make sure the open end is gone.
Step 7: Fold the bottom of the napkin to about 3/4 from the length as shown and press the valve well down.
Step 8: Turn the napkin again.
Step 9: Curl up both sides so that you can put them together in the middle.
Step 10: Put it upright and smooth it out, if you have problems keeping the points, grab the iron and look up the points where things are not quite right.
